Search results

I need two 260 Cowl T-handle tiedowns. ASAP. Thanks, John

I am looking for two good condition or new tie down bungee straps for a 260 cowl. Any one have two please give me a message asap. Thank, Johnny

Ordered some touch-up gel-coat from Bill (Allison), got it shiped to Miami to a friends address (so I havent seen it as yet). I plan on painting sometime in January. I know the instructions are enclose but is there anything else specific I need to add to the gel-coat before painting it? Anyone...

Have anyone tried using one of these type cones to lengthen a CLE cone? If so, are there any water suction problems? Just thinking of trying somthing but dont want to be a :beating dead horse.. Thanks j

I have two questions. Can an OMC SRX Prop fit a Mercury 2.5 Motor? If so, have anyone tried these props on an Allison? Thanks! Johnny

Looking for a good performance LH rotation prop for a merc small shaft. Prefer 28 > 30. Would be nice if its Allison Cut.. Thanks, Johnny

Stupid question:banghead, but where do I install the torque on a LH rotation lower? On the right hand side correct? Just want to be sure.. Thanks, Johnny

Hello Where can i get Allison (white) touch up gelcoat. Is there any aftermarket company out there that sell a good match without you hacking a piece off and sending it to them? Thanks, Johnny

Hi I am new here! To start off, I have a WHM Carbed (modified) 225 Promax power head with light flywheel, 20" off-shore mid. I am looking to mount on my Allison GSE. First thing I plan do is extend the setback to about 10" by adding another plate to the original 6" Allison plate. Any advice...