Search results

great condition $300.oo plus ship need to move

I have a mint 20" 6hp Yamaha that was put into service in 2010. In almost new condition, and will work on jon boats etc, I have a plate I made to lift it 5". Used very little and runs very well. Asking 800.00 obo. Only reason I am selling is I went to a bigger motor.

I need a steering wheel that fits the ride guide system that use the trim wire thru the bolt in the wheel. It has the 5 bolt holes. Need it asap. Anyone?

non preload pin, motor seized. I think it a late 80's early nineties in great shape have prop also 17pitch. $400.00

in good shape has flo torque hub with omc insert $215.00 shipped.

complete 260 electrics, coils, a15 packs, stator trigger just as it came off engine. $550.00 plus the ride. 260ss skirt-75.00 plus ship allison foil aluminum color-60.00 plus ship yamaha 70hp lower non preload pin-$400.00 plus ship 24 ron hill copy-$200.00 plus ride 7 7petal reed cages 2...

great shape $125.00 shipped

My old 99 comp that john richied owns now, had an employee who drew in pencil art and took this photo and did it for me. Was cleaning out a closet and found it, man what a boat and how I miss it. Maybe again one day.

top cowl bottom and skirt- $600.00 great shape

Clean bill of health from Brucato $1,000.00 shipped

24 cut down chopper little under 14" diameter be good for a v4 has a few dings $150.00 shipped Tillman 24 et copy ran very good on my Triad V21 and Grandsport $250.00 shipped 24 Ron Hill copy has insert hub thick blades not worked always used this to go to sandbar and back ran good , ran 95mph...

Comp boat, 480lbs rigged for merc. Also have a 2.5 laser inj motor pumped to drag specs by Mike Clemmons, 14 petal front, 30 over vertex,3/8 rod bolts new bearings thru out motor 260 electrics, a6 box 15" cut down mid 2 to1 lower with bobs cone.$4,000 boat and trailer $5,000 motor, mid and lower

have a 12 gallon and need an 8 gal. anyone have one they want to sale or trade?

like new $110.00 plus shipping

in good shape bottom top and skirt $400.00 plus shipping

8 of 10 came of triton bass boat. $250.00 shipped

was bought as a new block front half and divider plate has small rods, 2 ring merc top pin pistons, 7 ring crank, horn front half. no ecu or flywheel leakdown on motor is still good4-5%. $8,200.00 as is with flywheel $8,500.00 also know of a pretty fresh 2002 280 with 260 electrics if anyone is...

light layup with seats in it is arond 630lbs side steer ally seastar 6345 hydraulic steering 12k tach fuel volt temp livorsi gauges 16gal fuel cell with sump 6" jack can be sold with trim timer $13,400.00 looking for trades xr2001

20" offshore ridgeback with 260 one piece plate and choice of later model bell shape tuner or earlier long square tuner with trim pump and lines. $1500.00 plus freight

very clean 72 hours can demo motor only $3,500.00