Search results

Looking for a factory 2.5 15" mid. Thanks

Ok guys I know I can call Allison and order them but does anyone know where else you can get the ones that go around the steering cables in the rear wings?

Looking for 2 16 1/2 ft mercury ride guide steering cables. Thanks in advance

2002 XB 03 with 2000 225 pm 20 inch motor fat shaft sm boat is very clean. It I white and red on a single axle boatmate. Motor is spotless compression is 120 on all 6 still has oil injection. I can send pics to phone or email asking 21,500.00 thanks Tom.

I have a small bearing 260 front half no welds or repairs want to trade for a carb 7 petal front half it has been drilled for a 4 bolt block. Thanks Tom

Chip could you give me a call when you get a chance. Thanks Tom 502-803-5638

I have a 28 Allison cut clever small shaft 9 outta 10 no welds or repairs. 400.00 plus shipping. Thanks Tom

I have 5 props for sale sll with little run time. All props are 9 outta 10. 1. 22 small ear chopper with weed cutters stock 275.00 2. 30 small ear chopper weed cutters removed worked by Performance Propeller 275.00 3. 28 Throphy with vent holes 350.00 4. 27 Revenge 4 blade small shaft new...

I have a complete setup with Allison cylinder and adapter for the Allison wheel. Thinking about selling and going back to cables nothing wrong with it just don't like the feel at high speeds 1100.00 plus shipping. Thanks Tom

Would like to trade my SS for a XB 2002 comp. Thanks Tom

Anyone have interest in a complete dual cable steering system? It's in my SS now works fine just thinking about going to hyd. It will be a complete set up the cables are 16 or 16.5 foot long just got them from Allison 2 yrs ago. Asking 400.00 plus shipping. Thanks Tom

I have a 14.5x28 Hoss Hyperdrive small shaft 9 outta 10 500.00 shipped in the lower 48. Thanks Tom

I have a 15x26 Performer that has been ET cut 10 out of 10 only has 2 runs on it my boat just likes the 14 and 14.5 dia props. Asking 625.00 plus shipping Thanks Tom

Guys thinking about selling my SS. Its a great boat I have had a lot of fun it just putting it out there to see. It is a 98 Excel center steer with extra bucket and rear bench, both rear cowls. It also has new guages in it they are white faced with silver rims and red bezels,red billet switch...

Hey guys I wired up 24 volt trim but I also have 24 down as well I took the jumper out but still have 24 up and down. Any ideas thanks in advance Tom

I have a 24 ET cut done by Billy Eaves small shaft A5 chopper runs great only ran it 3 or 4 times strong runner asking 450.00 TYD in the lower 48 Thanks Tom

Guys a good friend of mine dosen't post on here much but dose read and buy a lot of stuff from different people. Anyway (Procomp) had a 28 ET listed for sale fro 550.00 which Baxter purchased from him and come to find out it wasn't a real ET but a cut chopper and had some welding done on it...

Guys looking for 1 maybe 2 complete set of 1.75 for a 2.5 lower. Thanks Tom

Would anyone be interested in a get together on Lake Cumberland? I have became good friends with one of the owners of the State dock he just bought a 2003 and is wanting to get a group together. Tom

Who do we send pics to? I want to update the pics of my boat on the SS 2000 page. Thanks Tom