Clarkb
Member
First off: Good Morning,
I have been creeping on the site for a while now and studying the diff techniques/tricks etc that you guys are doing. I finally got a Allsion a few moths ago an I'm doing a total restore on it. It's a 91 XB2002 with the sport console.(white and blue) I've ordered tons of new stuff and I'm finally geting started on it. It will be powered by a fresh 225PM. I'll try to post pics and updates as it comes along.
My first question is, I need the demensions of the two plates that hold the throttle cable/fuel line and wires in the cut outs. It s the two that are under the rear center hatch.(rough estimate is about 3x5in)
I'm going to make some out of aluminuim and use a laser ether to "enhance" them.
Thanks in advance and I'm sure you will be hearing(beging for advise) from me a lot over the next few months.
Gonna try to post a few pics from my phone below. Before it went into the chop cut rebuild shop. Haha
I have been creeping on the site for a while now and studying the diff techniques/tricks etc that you guys are doing. I finally got a Allsion a few moths ago an I'm doing a total restore on it. It's a 91 XB2002 with the sport console.(white and blue) I've ordered tons of new stuff and I'm finally geting started on it. It will be powered by a fresh 225PM. I'll try to post pics and updates as it comes along.
My first question is, I need the demensions of the two plates that hold the throttle cable/fuel line and wires in the cut outs. It s the two that are under the rear center hatch.(rough estimate is about 3x5in)
I'm going to make some out of aluminuim and use a laser ether to "enhance" them.
Thanks in advance and I'm sure you will be hearing(beging for advise) from me a lot over the next few months.
Gonna try to post a few pics from my phone below. Before it went into the chop cut rebuild shop. Haha
Attachments
-
14 KB Views: 195