Search results

Ran the hose to the same area where the front hatch drains into. The hole was large enough for both hoses.

I tapped into the drain on the front hatch of my XB2003. Used the same size tubing and ran it on the rod locker side. I'll take a few pictures tomorrow.

I have owned my XB 2003t since 1999. The boat still looks brand new, runs great and no stress cracks. I get asked a bunch of questions at the ramp about age and speed of the Allison. People are surprised it is a 1996 and think it is a few years old. My old 24 year old Allison will run faster...

Stockton, CA. I'm in central CA and still own my Allison 2003T with a SuperMag 225,

Stuart, Just did that yesterday and cleaned the manifold pressure tube with some carb cleaner. I think the manifold pressure sensor was plugged up. Thanks! Took a second look at it on Saturday. TPS adjustment was not too bad, it was tested at .240 this morning. Was set at .250 last night...

I have been working on a friends 200 Merc EFI (Serial Number OF068759). My friend said he can get the boat to start by giving it throttle upon start and prior to getting on plane, he said he had to rev the motor to 3500 rpms in neutral 8-10 times. After that he could get the boat to rev up and...

I use the bow eye and the front cleat. The back end sticks out and away from the dock a little.

I never replaced one before, is it pretty easy? It is a 1996 Supermag 225 with a sportsmaster gear case. I'm very mechanical and work on cars all of the time and do most of the simple maintenace on my Allison. I pulled the lower unit off and was replacing the water pump impeller and did a lower...

If the oil injection is still hooked up, check the reservoir under the cowling. The short beep will indicate low oil. Continuous beep is overheating. Good luck!

1996 xb2003t, 1996 225 pro-mag long shaft-(no mods still same powerhead), tandem trailer/no brakes, electronics, omc trolling motor. boat is wired for 3 batteries. 14" of set back/ trophy 26/ gps with 2 and gear at 87mph-hitting rev limitter. added some wood to the dash and steering wheel...

Stockton, CA (Delta) added links or pictures, plus some info on my baby/boat!!!

1996 xb2003t, 1996 225 pro-mag long shaft-(no mods still same powerhead), tandem trailer/no brakes, electronics, omc trolling motor. boat is wired for 3 batteries. 14" of set back/ trophy 26/ gps with 2 and gear at 87mph-hitting rev limitter. added some wood to the dash and steering wheel...

looking for one almost like that, but black insert, so it would match my other one. thanks

looking for folding bass seat. charcoal grey with black/charcoal grey inserts. have a 96 xtb have two butt seats and one bass seat. sometimes would like to remove bench and place two bass folders in rear. anyone have one floating around?

i have the same boat, but a 96 xb2003t, 96 225 promag, bobs nose cone, 14.5 inches of set back and about 1/4 above pad. fishing prop is a trophy 26 bumps rev limitter (GPS 87-88) with 2 on board and tackle/gas. just got a mazco re29 haven't had it for a run yet, but will keep you posted.

Thanks for the help and information. i'll look around and see what i can find out in the "Cali" area. been running a 26" trophy since i had the boat. bump'n rev limitter pretty hard. just got a prop from "ClimateMaster" on "Scream & Fly" board.

looking for a prop washer that will fit a mazco re-3 have an alli xb2003 with 225 promax small shaft. anyone know where i can find one new or used. thanks:relax: