Bill Kemp
Active Member
Two power heads one is a 1996 or 1997 year model 200 ported to 225 specs it has one cly down melted the piston it is a compete motor (except for the throttle and timing pivot arm) has 34mm carbs and all the electronics asking 650.00 as is or 1100 if I fix the down cly
The second power head is a old f1 block from Wayne worthy it has z-ported exhaust ports, finger ports, behind the liner ports(tube ports), rod slots have been cut it has a custum made exhaust divider, hydrotec 8200 heads motor is disassemble. I have a complete set of used Wisco forged piston with new rings and a complete set of new in the box pro marine coated pistons with rings both sets of pistons are finger ported the Wisco pistons are a little ruff but can be run without any problems there is a front half for carbs and a set of 34 mm carbs and also a Yamaha ox66 fuel injected front half that I was setting up for this motor message me for prices I will part out also have some lower unit parts and spare motor parts
The second power head is a old f1 block from Wayne worthy it has z-ported exhaust ports, finger ports, behind the liner ports(tube ports), rod slots have been cut it has a custum made exhaust divider, hydrotec 8200 heads motor is disassemble. I have a complete set of used Wisco forged piston with new rings and a complete set of new in the box pro marine coated pistons with rings both sets of pistons are finger ported the Wisco pistons are a little ruff but can be run without any problems there is a front half for carbs and a set of 34 mm carbs and also a Yamaha ox66 fuel injected front half that I was setting up for this motor message me for prices I will part out also have some lower unit parts and spare motor parts