Hydromotive quad ot

[tomoad]

Anybody got a picture of the exhaust vents on a quad 4 ot, I bought an older 1 from sam baker, & sent it to todd and he cleaned it up and blueprinted the blades, thinned them down, This prop doesn't have any vents in it, and told me if i needed them to send it back, I would like to see where there at, and what they look like. I may be able to cut or drill some in it. Just have to find out what size hole.

 

[TBuck2003]

Tomoad,
The standard size we start with is 5/16",on that wheel.You will need to put them behind the blade,1.25" up from the machined lab seal(part that slides into lower unit.)The outside diameter of hole should come right up to but not into back side of blade radius(where blade meets tube.)I have drawings if you need them or feel free to call and we will get you squared away.

Todd

 

[tomoad]

thanks todd

prop runs awsome, but i have yet to turn my motor hard i just had jsre rebuild it, I also think i can better the holeshot with some exhaust vents, again thanks todd for the info