had the xr out twice now, boat is a comp model, has a 260 on it w/ 8" of setback, 20" mid, has the lip(.044 in the center),bob's 200 case, propshaft is even w/ the pad, tried a mzco re3 29 p and a 28 et cut done by leading edge ,battery is installed in the back in front of the fuel tank, and boat has the drag plate installed under the jack plate. the boat gets alot of bowrise on takeoff(it does plane off fast), and once up and running (over 65 mph) is fine, but it porpoises at lo speeds(cruise , like 25 mph thru the 50's), no matter where you put the trim. i would like to be able to use this boat for cruising, but the porpoising drives you nuts!! going over waves is difficult(the bow is kitey) any suggestions???? thanks!!!! i was gonna try to go to river ranch w/ it this weekend(s&f event) but at this rate i might be taking my hydrostream
Last edited: