Torque for setback plate to Jack plate

[whipper]

I am going to raise my motor up one hole on the Allison setback plate. What torque setting do the bolts have when reattaching them? The reason is with the trim full up im just below even by1/8th best I can tell. I want to be able to run 1inch or 1/2 inch above or have the jack not fully all the way up hard when running. I shaved my lip down and could use the extra hight im sure. I seem to run to much trim as is.

 

[SLOmofo]

A squeek and 1 grunt. No more and no less! :rolling eyes :big grin

 

[FlatOutAlly]

did i read this right, mr. whipper? Why did you shave the lip off a Grandsport? Please bear in mind that I'm not nearly as smart on these lip things as Darris is, so why would you do that?

 

[ROBERT CROSS]

A squeek and 1 grunt. No more and no less! :rolling eyes :big grin

:rolling eyes That must be about right, couldn't find any specs at all in the install manual.

 

[F2008]

http://www.allisonowners.com/TransomStress50001.PDF

Mr. East seems to prefer 50 to 55 psi. PFT always seemed to work for me.

 

[Brack]

Whipper, how much offset are you running?.....next Question.....how much of the lip did you take off?