Tim Powell
Active Member
Got the Ultrex installed and in the recess without spacers. I ended up cutting the back corners of the pedal off with a dremel. The recess is too narrow in the rear to make the pedal mount in the same holes as the Fortrex pedal. I failed to take a pic showing what I cut off but basically about 1" of the left and right side of each rear corner of the plastic....when I did the original test fit I didn't have the bottom plate on and it was farther back but when I put the bottom plate on it pushed the pedal farther forward. I ended up trimming the both rear corners of the bottom plate but wasn't able to get it back quite as far as without.
Long story short, it's in and functional. I am not 100% happy with it but it is as good as it will get without major modifications to the pedal or boat.
The pictures make it look like it is touching the front graph trim piece but there is about 1/4" gap between the pedal and the trim piece.
Long story short, it's in and functional. I am not 100% happy with it but it is as good as it will get without major modifications to the pedal or boat.
The pictures make it look like it is touching the front graph trim piece but there is about 1/4" gap between the pedal and the trim piece.