XB02 Transducer Hole Cover

[Scott in MN]

Can someone post the dimensions of the cover for the access hole to the transducer, mine blew out of the boat last summer. I have some carbon fiber sheeting I made for switch plates and might as well make a cover also.....

Thanks,
Scott

 

[22R]

The plate is 6" by 6" even and has rounded corners. I snapped a couple pics with the iphone if you need them, Just PM a number to send them to.

22R

 

[Scott in MN]

Thanks, the pics will help for the corners. PM sent

Thanks again,
Scott

 

[John S]

Damn, Scotty is so fast, he's tearing the boat apart! If you need one for a mold, I can get you mine in a week or so when go to see Jay.

 

[Dave Hensley]

You can get the Flying A from Bill at the A Factory.

 

[Scott in MN]

Damn, Scotty is so fast, he's tearing the boat apart! If you need one for a mold, I can get you mine in a week or so when go to see Jay.

I already have the carbon fiber made up from leftovers. If this don't work I will probably buy one since there is no weight savings to be had there.

Thanks

 

[Scott in MN]

You can get the Flying A from Bill at the A Factory.

I will call him about a decal, that would look sharp....