I am new to A boats and you guys are the A boat gods! I need a good starting point to get this boat to handle. Here is what I have:
XB2002T 900lbs according to BILL.
225 looper rude no real mods other than fiber reeds.
Unknown low water pickup cone.
The only thing I can say for sure is that it does not look like my land & sea cone.
27 pitch over hub.
6 inch manual jack.
I have a 6 inch Bob's hydraulic I can stack or change. As best I can tell prop shaft is 2 inch below pad....and at that point the boat washes the sides.
Everything that I have read on this site indicates 2inch below is way to deep so yesterday I lowered it 1 inch. Tomorrow I plan to take it out and check the results.
I appreciate any input and advice you have to offer.
Thanks,
John
XB2002T 900lbs according to BILL.
225 looper rude no real mods other than fiber reeds.
Unknown low water pickup cone.
The only thing I can say for sure is that it does not look like my land & sea cone.
27 pitch over hub.
6 inch manual jack.
I have a 6 inch Bob's hydraulic I can stack or change. As best I can tell prop shaft is 2 inch below pad....and at that point the boat washes the sides.
Everything that I have read on this site indicates 2inch below is way to deep so yesterday I lowered it 1 inch. Tomorrow I plan to take it out and check the results.
I appreciate any input and advice you have to offer.
Thanks,
John