RB in NM
Active Member
Have any of you guys racing XR drags, ever heard of or seen a trim tab, mounted on the Portside stern transom bottom, near the pad,,,,to help control the typical torque on hole shot found on these hulls?
The plate is used in a down position upon full throttle, then as hull is on top , the plate comes up, fully out of the way on any water contact.
It is operated by foot pedal on left side.It's used like a clutch pedal, down until gas is applied, then let up as motion is underway.......
Interested in your replies to this..... :roll:
Later, 3 1/2 days and counting........Russ
The plate is used in a down position upon full throttle, then as hull is on top , the plate comes up, fully out of the way on any water contact.
It is operated by foot pedal on left side.It's used like a clutch pedal, down until gas is applied, then let up as motion is underway.......
Interested in your replies to this..... :roll:
Later, 3 1/2 days and counting........Russ