xb2003 which yamaha

[turbo d]

OK that's the way i am gonna do it first gears changed and a low water pic up, than we will see for an other prop.

 

[turbo d]

Turbo D,

You can contact one of my dealers in the Netherlands to get you a prop.

Gertjan Kooyman
Kamille 15
5331 Dn Kerkdriel
Gelderland Netherlands
Tel +310651103834

Tell him Todd from Hydromotive says you need a 26pitch QIV OT Special.25pitch if you want more holeshot and less Top End.Good Luck and welcome to the insanity.

TBuck

@ TBuck

so finely i get an other lower unit from a Yamaha 225 with 1.86 gear
and they gone put a nose cone on it
what prop do you recommend me, than i can order the prop :razz
Thanks,

 

[TBuck2003]

26 QIV OT Special and you will need to run it about 3/8" below pad loaded up and 1/4" below for solo flying or lighter loads.This is assuming your pad is stock.Good luck and let me know if I can help.

TBuck

 

[turbo d]

@ TBuck

my pad is not stock, the lip is off

 

[TBuck2003]

Than you can run higher but take it a 1/4" at a time.By the way your order was placed,need anything just let me know.

TBuck

 

[turbo d]

@ TBuck


Thanks,:beer:

 

[turbo d]

i made yesterday the first ride with the new prop and lower unit and i am very happy with it :big grin:big grin
TBuck Thanks

 

[bigtis]

it doesn't look like you have a torque tab on the skeg?:help

 

[chad202]

And the skeg doesn't look tall enough.

 

[aaronmt]

And the skeg doesn't look tall enough.

Ya it does look a bit small,who did the lower.

 

[turbo d]

The skeg is standard is it necessary an torque tab on the skeg
a company here in the Netherlands did the lower http://www.aquatech-boats.nl/index.html

 

[chad202]

The motor will run thru the water crooked without the tab and could possible cause issues.

 

[baitcaster]

Good looking LU, but Chad has a good point. I did run my 225 OMC for a while without a tab and it ran OK, but ended up putting a tab on it.

Have you run it yet? If so, how did she run?

 

[turbo d]

Good looking LU, but Chad has a good point. I did run my 225 OMC for a while without a tab and it ran OK, but ended up putting a tab on it.

Have you run it yet? If so, how did she run?

it ran Ok but it was not very fast 67 mile till so far

were can i order a good weld on torque tab for my skeg

 

[baitcaster]

Most after-markets are typically "bolt-ons," but I am sure you could weld them. They are cheep and you can find them just about anywhere, but I don't know what is available to you in the "Netherlands."

Most nose cone manufactures will do the mod when they do the nose cone, but I suspect that you could call Bob's and see if they would sell and send you their tab?????

 

[Stace]

I got my weld on tab from Allison. Just call Bill and have one shipped. Stace