Search results

1990 XTB with mid 80's Mariner 200, coned case reworked by JC's, cable steering, tandem axle trailer, 2nd owner boat. Including Minn Kota Terrova 80 electric steer trolling motor and 2 Lowrance HDS units (side scan and Ethernet ). Trolling batteries new in Aug 2016, new cranking battery, 24...

How many run the prop seal ring with a Trophy prop?? I was told this would help with the slip on take off. I've already been through all the various plugs, and the large seem to work best loaded, but it slips on take off pretty bad. Go smaller and it boggs down too bad. Any suggestions. Was...

Hey guys, Does anyone know about how much metal plate is actually glassed in for trolling motor mounting on the XTB. Getting ready to change and need to move mount around but not sure how much metal is there and how far forward. This is '90 model XTB.

My boat sits right on the center rollers of the trailer. I know from previous post this isn't the way it should be, but will new bunk boards solve this issue or is there something else I should investigate? Thanks David

Hey guys - We've got to make a trip to East Ridge, Tn next weekend for softball tournament. Anyone close to that area that can tell me where NOT to stay. Just want something clean. They are playing at the Camp Jordan fields. I see several around that area - just don't know what they are like...

Would like advice from XTB owners about where to mount my GPS Antenna. I know there was some previous discussions on this but haven't found those post yet. Any pics if available would be great too. Thanks. David

Just had propshaft seal replaced 2 weeks ago because it was leaking, and only 2nd time out I noticed today fluid leaking again from around propshaft seal area. I am taking it back this week but what should I expect. Any ideas? Also, they did a pressure check on the lower unit before replacing...

What could be the cause of the trim motor not working in down cycle? Works up but not down, this is the case on all trim switches in the boat. Heres how it started: Went to trim motor up and switch at the back of the boat was goofed-up, no spring tension on either side of the switch, so I...

I am in need of a 40amp push button circuit breaker for the trolling motor wiring. I have not been able to find a push button type that is rated at 40amps local or on the marine websites I have checked. I guess I can replace with an inline type instead. Just curious if anyone has baught one...

I am considering a new trolling motor and welcome any opinion about the Minn Kota powerdrive models. I was mainly curious to know if anyone has used them and if there were any mounting concerns with the powerdrive bracket. Thanks

Does anyone know where I can get a new O-ring/seal for the gas cap? Mine is coming apart and seems to be dry and brittle. Is this a special seal or will any local parts store have a suitable O-ring? Thanks

Can anyone tell me what the proper fluid level in the trim system should be and how to determine the level. Also, what type fluid should be added if needed :?: Thanks - David